It is currently Sun Sep 23, 2018 7:29 pm

News News of IBM

Site map of IBM » Forum : IBM

Servers, Desktops, etc.

Bladecenter Cicso switch reset PW after firmware flash

After performing a software/firmware upgrade on the Cisco BC switches the username and password has to be restored through a console connection to each switch – default password of “cisco” should be used to login.

1. conf t <enter>
2. username USERID priv 15 password PASSW0RD
3. ip http authentication local
4. end
5. wr mem <enter>
Read more : Bladecenter Cicso switch reset PW after firmware flash | Views : 2608 | Replies : 0


UEFI-aware operating system does not boot after load defaults or deployment - IBM BladeCenter and System x

Symptom

Loading the defaults in Unified Extensible Firmware Interface (UEFI) deletes the Boot Order entries for any UEFI aware operating system.
These entries are required to boot the operating system correctly.
Deployment images may also use this information to automatically boot an Extensible Firmware Interface (EFI) operating system for the first time.

Affected configurations

The system may be any of the following IBM servers:

    • BladeCenter HS22, type 7870, any model
    • BladeCenter HS22V, type ...


IBM Bladecenter Switch resets password after Firmware upgrade

After performing a software/firmware upgrade on the Cisco BC switches the username and password has to be restored through a console connection to each switch – default password of “cisco” should be used to login.

1. conf t <enter>
2. username USERID priv 15 password PASSW0RD
3. ip http authentication local
4. end
5. wr mem <enter>
Read more : IBM Bladecenter Switch resets password after Firmware upgrade | Views : 1812 | Replies : 0


When your customer cannot find the Defualt Password for a Product

This site has all default passwords for all different types of Hardware and Software.

http://www.default-password.info/


 

Login  •  Register


Statistics

Total posts 363 • Total topics 367 • Total members 43

cron